Front splitter

Information / Questions and Discussion -
Imps and Imp based Motorsport stuff from the olden days and current
Post Reply
Posts: 214
Joined: Mon Dec 28, 2009 6:44 pm
Club Member: No
Car Model: None

Front splitter

Post by speeddemon »

I am making a front splitter for the front of the spaceframe race car i have. The splitter will protrude around 3 inches at the front and go all the way back to the front floor.
Looking for some advice on where to finish the rear section which is going to attatch to the front of the floor /bulkhead. Need to know if its best to take the rear section all the way back to the full making it flushk or leave a small gap betwean the floor and the rear section. Is it also best to have it level with the floor or slightly lower.

Any knowledge and performance info will be gratefull.

Post Reply

Return to “Motorsport Forum”